how to install windows on hard drive not from bios

Whatever provisions your case makes for installing hard drives, once you've removed the cover it will almost certainly be obvious how the hard drive mounts within the case.

If that card will replace some or all of the embedded PATA or SATA interfaces, use CMOS Setup to disable those interfaces.

If you are also installing a PATA or SATA interface card or RAID adapter, configure that card per the maker's instructions and attach the cables to it.

Alternatively, use a diagnostic program such as Everest Home Edition to determine the current configuration of your drives and interfaces. Note the current configuration which ATA and SATA ports are in use and the descriptions of the devices that are connected to them.

Restart the system and run BIOS Setup.

Before you remove the case panels to install the hard drive:

Connect the data cable to the drive and to the PATA or SATA interface.

Configure the drive as a master or slave device (PATA only).

The basic steps required to install a hard drive are: If it works go into recovery mode, where you can get to the command prompt.The general procedures for installing any hard drive are similar, but the exact steps and the sequence of steps vary depending on the type of drive you are installing PATA or SATA and the particulars of your case.

Yet another suggestion: try the Windows XP CD for booting. However this assumes you actually manage to boot into the CD like that. As soon as it launches the installation you just plug it back in and the installer should recognize it. Though I think you should be able to make a boot CD as well.Īnother solution for forcing the CD is simply unplugging the hard drive, you know for sure it's not going to load Windows then. Once setup begins remove the 98 floppy disk. Press ENTER to continue without Smart Drive. (Replace the X with your your CD-ROM drive letter). When you get to the A:> prompt insert the XP cd.Īt the A:> prompt press ENTER after typing each of these three lines.

(Floppy needs to be set as first boot device in the BIOS) To start the installation using a Win98 boot disk. If you can't start the XP installation by booting from the CD-ROM, it is possible Googling often gives you results like: press F8 when in BIOS, but I don't think that really helped.Ī solution that should work is creating a boot disk (on a floppy), but this requires you to have a floppy drive. I had a similar problem when installing Windows 7 on an old laptop with Ubuntu on it.

How to install windows on hard drive not from bios